Laser collimators for telescopic sights and riflescopes
Buy cheap laser/optical collimator for weapons
Every shooter, whether he is an airgun shooter, firearms shooter or hunter, wants to have his weapon correctly calibrated so that he does not miss a shot. The work of calibrating and adjusting a scope can be a bit tedious and cumbersome if it is to be done correctly. In addition to this, with movement and recoil, scopes can lose their calibration and may need to be recalibrated. The way to avoid wasting time calibrating is to use collimators, which use laser technology to propagate a beam of light marking the trajectory of the barrel in order to calibrate the scope immediately and reliably.
What is a collimator?
It is an instrument used to perfectly calibrate the sight or scope of a weapon in a quick and easy way. There are two types of collimators: laser or optical.
Is a laser or optical collimator better?
Optical collimators are the ones that have always been used. Laser collimators are gaining more and more market share to the detriment of optical collimators.
Laser collimators are easier and faster to use, but optical collimators still have a higher accuracy when calibrating.
Are collimators universal?
It is very important that you check the collimator’s data sheet to make sure it fits your caliber. Many collimators usually include detachable jaws for different types of calibres, so they have a high degree of universality and can be used for different firearms, airguns or hunting weapons. On the other hand, there are other models that are specific to a single calibre. When purchasing, it is important to check in the description the compatibility of the collimator.
What are the collimator screws for?
These are calibration screws. Most collimators have two screws to calibrate the laser beam, as it is necessary that it is perfectly calibrated to obtain a good performance. In case you want to calibrate at a specific distance taking into account the fall-off, these screws will also allow you to do so.
How to calibrate a universal collimator
If you want to calibrate a collimator with an eccentric configuration where you don’t want to adjust the drop, you must insert it into the barrel of the gun or a similar place that won’t move and will fit just right and rotate it, correcting the deviation until the dot rotates on itself. A “home-made” way of doing this is to insert the collimator into a mechanical screwdriver. After performing the calibrations, the collimator should make a fixed point even though the drill rotates. In the following video, you can see how to collimate a collimator using a drill:



















